To configure the sensors you must:

1) With the alarm disarmed, type in the base code (1234). If you have changed it, type your chosen code;
2) Then press the "microphone" key on the main unit, effectively setting it to "learn" mode;
3) Within 30 seconds, activate your desired receiver/sensor without it being put in place, so as not to trigger the anti-stop contact at the rear;

   3.1) If the receiver is a remote, press the arm button and you will hear a beeping sound on from your alarm;

   3.2) If it is a door contact, move the contacts away and you will should hear a confirmation beep from your alarm;

   3.3) Iff it is a motion sensor, press the button behind the sensor and you will hear a beep from your alarm;

4) Your receivers/sensors are now configured.